Grundfos Grundfos low water pressure electric booster pump system. MQ All-In-One Home Water Supply Pump. "Whisper Quiet Operation". Specially designed for domestic applications where low noise is a major consideration. The pump is cooled by the pumped water which eliminates the need for a noisy cooling fan. Ships next business day
Up to 5 water outlets can be operated at the same time without substantially reducing performance, assuming an average delivery of 3 GPM at 30 PSI and a 15 ft. suction lift.
Specifications
Applications: Domestic water supply. Pressure boosting from well or city. Automatic water transfer.
Type of pump: Single stage, self-priming centrifugal
Pump construction:304 Stainless steel and corrosion-resistant materials.
Inlet & outlet: 1" MNPT X 1" MNPT(male pipe thread)
Cut-in pressure: 30 PSI factory setting
Maximum operating pressure: 109 PSI (Suction pressure plus discharge pressure cannot exceed 109 PSI)Tank size: 0.7 Gallons
Suction lift: Capable of up to 25 feet
Maximum inlet pressure: 44 PSI (Must install a pressure reducing valve on the suction side of the pump if the inlet pressure is more than 44 PSI)
Electrical: 220-240 volts, 1 phase, 4.5 Amps., 60 Hz, 1000 Watts, 1 HP, TEFC motor. Includes 6' electrical cord with bare leads.
Maximum water temperature: 150 degrees Fahrenheit
Carton Dimensions: 24" high, 24" long, 12" wide.Weight: 36 lbs
NOTE
DO NOT EXCEED A TOTAL SYSTEM PRESSURE OF 109 PSI. THE TOTAL SYSTEM PRESSURE WILL BE THE INCOMMING CITY PRESSURE PLUS THE MAXIMUM OUTPUT PRESSURE FROM THE DATA ABOVE. THE MAXIMUM ALLOWABLE CITY PRESSURE FOR THIS UNIT IS 40 PSI
USE A PRESSURE REGULATING VALVE IN THE SUCTION AND/OR DISCHARGE LINES AS REQUIRED
Watts # N45BU-1, direct acting, water pressure reducing valve. Reduces high inlet pressure from up to 400 PSI to a lower adjustable outlet pressure from 25 to 75 PSI.
1" FNPT union inlet and 1" FNPT female outlet (no union)
The Gard-it switch is wired in series with a conventional pressure switch. If pump loses it's prime the system pressure will fall considerably below the cut-in point of the regular pressure switch. Gard-it will disconnect the pump motor.
Pressure relief valve 1/2" heavy duty bronze pressure relief valve for shallow, deep well and submersible pumps. Recommended only for cold water system installation. Spring loaded and pre-set at 100 PSI (Not adjustable). Not for use with hot water heaters.
Polyslab Pump Cover is water resistant with cooling vents to allow for hot air to escape and cool air to be drawn in. It has easy to follow, cut and snap entry points for easy installation of pipes. It has multiple points to secure the Pump Cover to the Polyslab base to keep it locked safely in place. It has been specifically designed to allow water to escape the cover in case of pipe failure. They are available in tan or green colors. Dimensions 25.2” long, 13.4” Wide, 21.65” High, 10 lbs
Ships next business day