The Pedrollo PKm200 pump is used for pumping clean water without abrasives and liquids that are chemically non aggressive to the materials of construction. They are suitable for boiler feed , water misting, domestic use and as boosters for irrigating gardens. Installation: Must be installed in enclosed places, or at least protected against inclement weather.
Suction lift: 20 feet Not self priming. Must install check or foot valve in suction line.Liquid temperature: Up to 140°F
Ambient Temperature: Up to 104°F
Construction Cast iron pump casing with 1" threaded ports. Aluminum motor bracket with brass insert; reduces starting difficulties due to seizure of the impeller after long periods of inactivity. Brass radial peripheral vanes impeller. Stainless steel motor shaft. Ceramic, graphite and NBR mechanical seal.
Connections: 1" female threaded ports
Motor: The pump is close-coupled to a PEDROLLO electric motor, quiet running, totally enclosed fan cooled (TEFC), suitable for continuous duty.
Electrical: 2 HP, 3450 RPM, 12.5 Amps, 230 Volt, 1 Phase, 60 Hz, 1.15 Service Factor, class F insulation.
Power Cord: None
Duty Cycle: Continuous
Dimensions: 16 x 8 x 12 Weight: 40 lbs
Pedrollo PKm200 Series Turbine Pumps With Peripheral Impellers |
Model USA |
Volts |
HP |
Ph. |
Max. Amps |
Wt. Lbs |
Connections |
PKm200 |
230 |
2 |
1 |
12.5 |
35.3 |
1" X 1" |
Pump Capacity Table |
Model |
HP |
Total Dynamic Head In Feet And (PSI)
|
Shut-off (PSI) |
25' (11) |
50' (22) |
75' (33) |
100' (43) |
125' (54) |
150' (65) |
175' (77) |
200' (87) |
225' (97) |
250' (108) |
275' (119) |
300' (130) |
Gallons Per Minute (GPM) |
PKm200 |
2 |
- |
19.8 |
18.0 |
15.8 |
14.0 |
12.5 |
10.0 |
8.0 |
6.2 |
4.0 |
2.0 |
- |
296' (128 PSI) |