  
CHEMTRAVELLER 115 Volt AC Sotera transfer pump with Santoprene diaphragms, 1" X 14' EPDM discharge hose, 1" X 9' EPDM suction hose, ball-valve nozzle, and high profile tubular frame. For transferring agricultural products such as herbicides, insecticides, fungicides, matricides, water, acid, sludge/slurry, hydraulic oil, lube oil, waste oil, diesel fuel, detergents & chemicals. Ships in 1-2 weeks.
Specifications
- Duty Cycle: 30 minutes, not for continuous operation.
- Construction:
Spray coated cast metal motor, glass filled polypropylene pump with polypropylene , fluorocarbon ( Santoprene, Buna-N)and stainless steel internal wetted parts.
- Pump:
Reciprocating spring-driven, dual diaphragm design
- Motor:
1/4 HP, 115 volt , Explosion proof UL listed
- Particle tolerance:
Up to 0.1" diameter
- Battery cable/battery clips:
20'
- Discharge pressure:
15 PSI Maximum
- Flow rate:
- 15 GPM (1.5 cps fluid)
- 12 GPM (350 cps fluid)
- Discharge hose:
EPDM 1" X 14'
- Suction hose:
EPDM 1" X 9'
- Nozzle:
ball-valve
- Maximum Outlet Pressure:
15 PSI (1.09 BAR)
- Maximum flow rate¹:
13.0 GPM (49.3 LPM)
- Maximum Viscosity of fluid pumped:
3000 CPS (SAE140 Gear Oil at 68°F)
- Maximum ambient operating temperature:
130 °F (54 °C)*
- Minimum ambient operating temperature:
-10 °F (-23 °C)
- Minimum dry vacuum:
10 Inches of Hg.
- Minimum suction lift:
10 Feet
- Dimensions:
21.5" High, 15.5" Wide, 18" Deep
- Weight:
50lbs
- NOTES¹
Nominal flow rate at nominal voltage using a standard hose and manual nozzle with low viscosity fluid. ** The lift in feet is equivalent to the vertical distance from the surface of the fluid in the tank to the inlet of the pump, PLUS the friction losses through the vertical and horizontal runs of pipe, all elbows and other fittings. The system should be designed to require a minimum amount of suction lift.
- DANGER:
NOT FOR USE WITH GASOLINE OR ALCOHOL OR ANY FLUID THAT HAS A FLASH POINT BELOW 100 DEGREES FAHRENHEIT.
|