Pump Installation

1) If galvanized pipe is used, both the suction and discharge pipe should be supported ast a point near the pump to avoid strains being placed on the pump.

2) The suction pipe should slope upward from the water source to the pump. Locate the pump as close to the water as possible keeping the suction pipe as short as conditions permit.

4) A foot valve located in the water or a check valve located as close to the water as possible will reduce priming time of the pump and help maintain prime. A strainer must be used on the suction line to filter out dirt and debris.

5) Install a gate valve or a full opening ball valve and a union in the discharge of line. Install a union in the suction line. For removal or the pump for service, close the valves and disconnect at the unions.

CAUTION: Do not use globe valves or other restricting type of valve at the discharge. This will seriously restrict the capacity of the pump.