Sump & Sewage pumps Do's and Don'ts

• Always disconnect the pump from the power source before handling

• Size the pump to the proper capacity of the home. In a two-pump system each pump should be sized to meet the homes pumping requirements

• Consider a two pump system with an alarm where an installation may become overloaded or primary pump failure would result in property damage.

• Inspect pump for any visible damage caused by shipping. Do not install a damaged pump. Contact vendor if pump appears to be damaged

• Thoroughly read all installation material provided with the pump

• Review all applicable local and national codes and verify that the installation conforms to each of them

• Always connect pump and controls to a separately protected and properly grounded circuit. (GFI recommended)

• Be sure that the pit is large enough to allow proper clearance for the pumps float switch.

• Clean all built up debris in sump pit.

• Be sure that the pump has a hard, flat surface beneath it.

• Install a check valve and a union in the discharge line.

• Drill a 3/16" weep hole between the check valve and the pump housing.

• Verify that the sewage pit is gas tight and well vented to prevent odors

• Keep all warranty information, installation instructions, and receipts for future use.

• Ever cut, splice or damage the power cord.

• Carry or lift the pump by its power cord.

• Use an extension cord with a sump, effluent or sewage pump

• Use a discharge pipe smaller than the pumps discharge size.

• Flush any items that are not biodegradable such as paper towels, feminine hygiene products, condoms, or other items that could jam the pump impeller. A moderate amount of tissue paper in a solids handling sewage system is acceptable.

• Pour chemicals into the pump system such as acid’s, floor wax, paints, or any degreasing chemicals.