Rain Barrel Pump

Proven Pony Pump non-submersible self-priming rubber impeller rain barrel pump. . Designed for intermittent use only with 15 mimutes "on" and 45 minutes "off". The model 360PP is not intended for permanent installations or long, extended periods of continuous use.

Specifications

Applications: Ideal for pumping water out of rain barrels. Can be used to empty waterbeds, drain water heaters or aquariums, pump out a basement, transfer water to an RV, pump boat bilges, pump out stock tanks, and in just about any other application where water needs to be transferred.

WARNING: Specifically NOT RECOMMENDED for use with soap detergents, gasoline, waste oil, fuel oil, flammable, explosive or combustable liquids.

Construction: Nickel plated brass volute and housing; 304 Stainless Steel cover cnd cam; Buna-N impeller and shaft seal

Duty Cycle: Designed for intermittent use only with 15 mimutes "on" and 45 minutes "off". Not intended for permanent installations or extended periods of continuous use.

Inlet & outlet: Dual threaded. 3/4 male hose thread (MGHT)outside and 3/8" female national pipe thread (FNPT) inside.

Suction Lift: 7 feet maximum

Intermittent Water Temperature: 120 degrees Farenheit

Electrical: 115 volts, 1/10 HP, 1 phase, 60 Hz, 1.6 amps, 6' power cord

Dimensions: 3.4" high, 6.7" long, 4" wide.

Weight: 3.5 lbs

Availability: Usually ships next business day

Note:

90 day manufacturer's warranty from date of purchase.
Pump must not run without liquid.
No warranty whatsoever on impeller wear for any reason.
Under ideal conditions an impeller can last up to 300 Hours
Once initially primed, pump will re-prime if installed and operated correctly.
Recommended 5/8" minimum hose ID

Included accessories:

Two extra impellers and gaskets included with pump

Pump Capacity Table
Model	Total Dynamic Head
	1'	5'	10'	15'	20'	30'	40'	Shut Off
	Gallons Per Minute (GPM)
360 (555502)	5.7	5.5	5	4.75	4.5	1.5	1.5	48 ft. (21 PSI)