Liberty Submersible Sump, Effluenf and Sewage Submersible Pump 2" discharge, 2" solid handling, vortex impeller 120 GPM 4/10 HP 115 Volts 1 Ø # LE41M-2

Liberty heavy cast iron submersible sump, effluent and sewage manual pump (no float switch) with corrosion resistant plastic "HYTREL" impeller, 120 GPM, 2" discharge, 2" solids handling capacity, 4/10 HP, 12 amps. 115 volts, 1 phase, 60 Hertz, oil-filled, thermally protected motor with 25' cord.

Specifications

Construction: Heavy cast iron casing and motor cover; 2-vane, corrosion resistant plastic "HYTREL" impeller; stainless steel fasteners and rotor shaft. Oil-filled, thermally protected motor. Permanently lubricated bearings.
Solid handling: 2"
Impeller: Vortex
Outlet: 2 FNPT
Float Swith: None
Minimum sump diameter: 18"
Maximum fluid temperature: 140 degrees Fahrenheit
Major Width: 10.75"
Height: 14"
Electrical: 115 volts, 1 phase, 60 Hz, 4/10 HP, 12 amps, 25' power cord with grounded plug. Quick disconnect power cord allows replacement of cord in seconds without breaking seals in motor.
Carton Dimensions: 14" high, 12" long, 12" wide.
Weight: 39 lbs.

Capacity Table # LE41M-2 In Gallons Per Minute
Model	HP	PH	Volts	Amps	Cord	Size	Total Dynamic Head (TDH)				Shut-off (feet)
							5'	10'	15'	20'
							Gallons Per Minute (GPM)
LE41M-2	4/10	1	115	12	25'	2"	120	95	50	0	19'


		Sewage Pump Simplex System Components For a simplex installation order one each pump, one (1) level switch (either with 115 volt, 230 volt "piggy back" or bare leads wide angle switch) , one (1), level switch weight, one (1) discharge check valve, one (1) ball valve and one (1)high water alarm

		Sewage Pump Duplex System Components For a duplex installation order two (2) pumps, four (4) narrow angle level switches , two (2) each discharge check valves, two (2) ball valves , one (1) mounting bracket and one (1) duplex control panel.