Flojet Quad II Demand Pump 3.8 GPM 115V 45 PSI # 4300-545A

3.8 GPM-45 PSI, Flojet 115V. Self Priming Diaphragm Quad Demand Water Pump model 4300-545A replaces model I30105011. Built-in pressure switch automatically starts and stops the pump instantaneously when the discharge valve opens or closes. 4300-545A has EPDM valves instead of Buns N. It is the Buyers responsibility to verify compatibility

Suitability for the application should be determined by actual use and is the full responsibility of the buyer. No warranty, expressed or implied, can be extended by the equipment manufacturer where failure is caused by chemical attack on pump materials. Temperature, aeration, concentration, and other factors may change the effect of the specific fluid on the pump materials. Only pumps with Santoprene / EPDM elastomers are recommended for potable water. Units are NOT designed for permanent residential domestic water applications.

Specifications

Operation: Built-in pressure switch automatically starts and stops the pump instantaneously when the discharge valve opens or closes. Duty Cycle: Intermittent. Can be run continuously for short periods of time. The higher the duty cycle the shorter the expected life of the pump. Applications: Automatic water systems, liquid transfer, spraying, cooling, circulation, filtration and dispensing. Special Features: Built-in pressure switch. No shaft seal. No metal contact with liquid. Ball bearing construction. Self priming. Can run dry. Wetted Parts: Modified polypropylene housing, EPDM check valves and Santoprene diaphragm. # 2090104 (45 PSI) pressure switch , motor mounting,# 20132-000 gromment kit and 2 Each # 20381-002 straight hose barb adapters and 2 Each 20381-009 elbow 1/2" hose barb adapters. Inlet & outlet: Plug-in ports to accept removable adapters. 1/2 hose barb adapters included. Other adapters available for easy installation. Electrical: 115 volts, AC, 1.5 amps, ball bearings, 6' cord with plug Pressure switch setting: 30 PSI Cut-in, 45 PSI Cut-out Maximum Operating Pressure: 40 PSI Maximum Suction Pressure: 30 PSI Priming capabilities: 6 feet dry prime Minimum Spray Tip Required: 9/64" (Spraying applications only) Carton Dimensions: 4" high, 10" long, 4" wide.

The FloJet Flojet Quad II Demand Pump 3.8 GPM 115V 45 PSI # 4300-545A can be used for moving wine around quickly and efficiently. It is self priming for easy starting. It is not made to handle high temperatures.