Flojet Quad II Water Pressure System 3 GPM 115V 30 PSI # 2840-000

Flojet 3 GPM @ 30 PSI Flojet 115 Volt Automatic Self Priming Diaphragm Demand Water Systems are designed to provide steady water pressure and generous water flow. The pump is fully automatic with a built-in switch and check valve to maintain pressure and will supply smooth water flow from a trickle to full flow.

Suitability for the application should be determined by actual use and is the full responsibility of the buyer. No warranty, expressed or implied, can be extended by the equipment manufacturer where failure is caused by chemical attack on pump materials. Temperature, aeration, concentration, and other factors may change the effect of the specific fluid on the pump materials. Only pumps with Santoprene / EPDM elastomers are recommended for potable water. Units are NOT designed for permanent residential domestic water applications.

Specifications

Applications: Typically used in large yachts, motor homes & bus conversions where high volume is required for multiple fixtures and amenities (washing machine, dishwasher, ice maker, reverse osmosis filters and water purifier. Also used in small domestic and commercial applications where the water supply is very low or fluctuates widely. Construction: Santoprene diaphragm, EDPM check valves, polypropylene housing, butyl accumulator tank diaphragm and polypropylene tank liner. Includes: Pump, motor, # 2096-540 (40 PSI) pressure switch, # 20132-000 motor mounting grommet kit, # 20381-022 port kit (includes one each 20381-018 Quad port X 3/4" hose barb 90 elbow and one each # 20381-014 Quad port X 3/4" straight hose barb Adapter), # 01745-000 s.s. 40 mesh inlet strainer Inlet & outlet: Plug-in ports to accept removable adapters. 3/4 hose barb adapters included (one each 20381-018 Quad port X 3/4" hose barb 90 elbow and one each # 20381-014 Quad port X 3/4" straight hose barb Adapter). Other adapters available for easy installation. Electrical: Permanent magnet (with solid state rectifier)ball bearing type, TEFC motor with long life brushes. 115 volts, 1 Phase, 50/60 Hz. 1.5 amps maximum. Pressure switch setting: 27 PSI cut-in, 40 PSI cut-out Liquid temperature: Minimum 45 degrees Fahrenheit. Maximum 130 degrees Fahrenheit. Priming capabilities: 5 feet dry prime. 15 feet when wet. Maximum suction pressure: 30 PSI Tank volume: 1.1 Gallons. Tank pre-charge: 25 PSI Weight: 16 lbs.