No longer available. Obsolete. Rule Pumps RM750A, All-in-one pump & switch (no float switch required), Automatic 750 GPH submersible 12 volt DC bilge pump preferred by yachtsmen and commercial fishermen worldwide. The Rule Mate series of Bilge pumps feature a solid state water sensing technology that eliminates the need for a separate float switch. It features an easy clean snap lock strainer, anti-fouling impeller.
Amp Draw @ 12.0 Volts: 2.7
Amp Draw @ 13.6 Volts: 3.1
Fuse Size: 5 amps
Connections: one straight and one angle Hose barb fitting.
Discharge Opening: 3/4"
Discharge Finish: Barbed
Housing Material: ABS
Strainer Material: ABS
Impeller Material: Nylon
Shaft Material: Stainless
Seal Material: Nitrile/Teflon
Temperature Limit: 200 degrees F
Fluid Capabilities: Bilge Water
Typical Life: 1500 hours
Shut-Off, (0 GPM): 12'
Footprint: 2.75" x 4.5"
Wire Length: 29"
Wire Gauge: 16 AWG
Box Dimensions: Height: 4.5" Width: 6" Depth: 3.25"
Weight: 1.4 lbs
Certifications: ISO 8846, ISO 10133, CE Certified EN50081-1 & EN50082-1, UPC Code 042237-111081
Automatic Operation: When water enters the bilge and reaches a certain height (2-3/4 inches) a sensor turns the pump on. After the water is pumped out, another sensor shuts the pump off.(On 2-3/4"; Off 1/2")
The sensor's unique "field effect" technology will only recognize water. If a 100% concentration of oil is detected the pump will not activate. This is not a zero discharge prevention system. The result is the most technically advanced bilge pump available in the marketplace.
|Capacity # RM750A Automatic Pump In Gallons Per Hour
|| Head In Feet
|Gallons Per Hour |
Note: Output is based on 10 hour break-in period and at 13.6V (12V models)