Your First Choice for Pumps and Pump Systems
Call Icon Call (305)-754-0677 M-F 8am - 4pm EST | Contact | FAQ

Oasis Deep Well Pump Typical Platform Mounting

Oasis Deep Well Pump Typical Platform MountingThe major components of a complete installation are as follows:
  • PUMP - INCLUDED
    • Height: 18
    • Base Diameter: 7
    • Discharge Port: 1-1/4 Female pipe thread
    • Suction Port: 2 female pipe thread for drop pipe.
    • Pump Rod Size: 3/8 diameter with adapter to 1/2 rigid Schedule 80 PVC plastic pipe.
    • Pump Rod Stroke: 3 1/2
    • Fasteners And Upper Pump Rod: Stainless steel.
    • Weight: 6 lbs
    • Note: Has stainless steel upper rod with adapter to attach pump rod.
  • CYLINDER: - INCLUDED (The component that goes down the well).
    • Height: 29
    • Outside Diameter: 3 1/8
    • Inside Diameter: 1 7/8
    • Pipe Size: 2 PVC slip fitting (solvent weld)
    • Plunger: All Brass with 3 cup leathers and stainless steel pump rod adapter.
    • Pump Rod Size: 1/2 PVC slip fitting (solvent weld)
    • Cylinder Barrel: Made of rigid PVC.
    • Capacity: Approximately 2 Gallons. per 50 strokes
    • Weight: 5 lbs
  • PUMP STAND (NOT INCLUDED)
    • Can be fabricated from wood or steel and must be high enough to allow access to the well seal bolts
    • Fasten pump flange to the fabricated platform. (using 1/4 fasteners )
  • DROP PIPE (2 schedule 40 rigid PVC plastic) : - NOT INCLUDED
    • Connects the pump to the cylinder in the well
    • Carries the water to the surface
    • Comes in 20 foot lengths, and can be glued (solvent weld) or screwed together using couplers * - purchase locally
  • PUMP ROD (1/2 schedule 80 rigid PVC plastic) - NOT INCLUDED
    • Located inside the drop pipe
    • Connects the pump handle to the plunger assembly in the cylinder
    • The hollow PVC pump rod actually floats and therefore reduces the pumping effort
    • Comes in 10 foot lengths, and can be glued (solvent welded) or screwed together using couplers * - purchase locally
  • WELL CYLINDER: INCLUDED
    • 1 7/8 I.D. rigid PVC plastic
    • Has a brass plunger with 3 cup leathers, and is the actual pumping component that goes down the well
    • The up and down movement of the plunger (activated by the pump handle and pump rod) brings the water to the surface
    • Has adapter to connect to the pump rod.
    • Has external foot valve
  • WELL CASING - NOT INCLUDED
    • Installed by a well driller - 4, 5 and 6 are common sizes
  • WELL SEAL - NOT INCLUDED
    • Used to seal the top of the well casing where the drop pipe goes in
  • NOTE: ENOUGH DROP PIPE AND PUMP ROD IS REQUIRED TO LOCATE THE CYLINDER 15 FEET BELOW THE SURFACE OF THE WATER.PLATFORM - NOT INCLUDED

Questions & Answers

(?) Ask a question about Oasis Deep Well Pump Typical Platform Mounting
Back to Top